|
|
|
||||
|
||||
|
reciver glitch... -
02-23-2006, 10:25 PM
ok when i turn on my truck and controler the thorattle servo tweaks out..not the stering...like at first its fine then after a few min itll start to tweak just a little bit but it gets worse and worse till the point of full thorattle to full brake....did my reciver go bad?
|
|
|
||||
|
||||
|
02-23-2006, 10:29 PM
You're supposed to turn on the radio then receiver. Even Chris Chiannelli (sp?) said it so it must be true!
 lol he even has a dvd!
|
|
|
||||
|
||||
|
02-23-2006, 10:32 PM
but when i would turn my controller off it would stop twitching then i would turn on my controller and the thoratol would twitch again...then i pushed the front end real hard to make the skid plate hit the ground and it stoped for a few sec..
|
|
|
||||
|
||||
|
02-23-2006, 10:33 PM
Is there some binding somewhere or metal to metal or loose screws?
|
|
|
||||
|
||||
|
02-23-2006, 10:39 PM
everything seemed good..i dont know im gonna buy a reciver this weekend off of ue-maxx and see what goes on from thier
|
|
|
||||
|
||||
|
02-23-2006, 10:43 PM
ahhh the reason i dont run electric, well it might be this wire, or this one or this one or that one or this one or the other one.... lol
www.czech-it-out-graphics.com 1/29/07 never forget....TTT  Bringing old know-it-all blow hards back to reallity at a forum near you "Always Imitated, Never Duplicated"
|
|
|
||||
|
||||
|
02-23-2006, 10:54 PM
i know i was just saying...like how I have some many problems with electronics and never can figure out what exactly it is
www.czech-it-out-graphics.com 1/29/07 never forget....TTT Bringing old know-it-all blow hards back to reallity at a forum near you "Always Imitated, Never Duplicated"
|
|
|
||||
|
||||
|
02-23-2006, 10:57 PM
yea i know what u mean..if im haveing electrical problems on a nitro maxx...wow i would be lost with a electric car..lol
|
|
|
||||
|
||||
|
02-23-2006, 11:09 PM
dude i used to solder my own batteries, after 2 fires I just gave up hahahah
www.czech-it-out-graphics.com 1/29/07 never forget....TTT Bringing old know-it-all blow hards back to reallity at a forum near you "Always Imitated, Never Duplicated"
|
|
|
||||
|
||||
|
02-23-2006, 11:12 PM
first thing to do is swap the throttle and brake servo channels to see if the problem follows the servo to the other channel. that will tell you eally quick if its the servo.
Now if the glitch stays on the same channel even when you swap servos its a TX/RX problem. at that point try your TX on someone elses truck by switching to their channel on purpose (Duh ask them if you can test it of course!! lol) . if the glitch appears on the other persons truck its the Tx that has a problem. Lastly swap out the RX. 1:1.. 01 Z28 Camaro A4 Sure.. its stock. 1:8's.. K3, Inferno GT, and a straight line beater car 1:18.. RC18t Mamba and 3s lipo
|
|
|
||||
|
||||
|
02-23-2006, 11:14 PM
ill try that i have differnt tx and rx laying around im gonna switch them
|
