|
|
|
|||
|
|||
|
FS:REVO 3.3 Spectrum DX3 Graphite Extended -
05-11-2007, 04:58 PM
You are looking at a near new (you won't know the difference!) Traxxas REVO . This is only one week old. Every thing you see is bought by me brand new. Ran only 3 tanks of sidewinder 20% fuel after motor break in. Motor should be ran as a brand new motor for at lest 5 more tanks. (Low and High needles are still set to rich mixture....) This is my beauty truck, I went all out on this thing buying the best parts for performance and ready for race. One more thing I would like to say is. This REVO with this Picco is absolutely insane!!! You will love this truck. I should sell this truck as brand new. But I'm listing it as used because There are some minor scratches on the bottom. I did take out revers gear to prevent from striping. Forward only. No reverse.
PM me to see Ebay add or search for pain711 on ebay if you would rather buy from Ebay.............. Paypal only!!!!!! looking for $900.00. I have over $1500.00 in this easy. Upgrades To the REVO Spectrum DX3 radio and receiver JR charger and rechargeable Spectrum battery Vantage Racing Graphite Extended Chassis Vantage Racing Graphite Tank Shield Vantage Racing CVD SHAFT Center OFNA Picco .28 With ROTO Start and Pull starter included New ERA Models Revo Big Block Conv. Kit REV111V2 Aluminum Bumpers Front & Rear RD logics CVD SHAFT FRONT/REAR RD logics ALUM. MID FRONT center and rear SKID PLATE RD Logics Aluminum Transmission Guard RD Logics Steering Block RD Logics Aluminum Handle Bar RD Logics Aluminum Arms Set RD Logics Aluminum Front Body Mount With Body Mount Post RD Logics Aluminum Rear Body Mount With Body Mount Post Pro-Line Aluminum Steering Arm Pro-Line Badlands MT Monster Truck Tire (Bead Lock) Maximizer Bead Lock 17mm Half Offset (28mm) Black Monster Truck Wheels Trinity Pipe & Manifold K-factory Shock mounts K-factory Rocker arms K-factory Disk Break vented Ofna 17mm Hubs Airtronics 94359 servo ($139 at tower) Throttle servo is a futaba 3305 Red Shock socks Traxxas onboard battery and charger Igniter and Charger Revo Body Intagey 17 and 22mm wheel wrench 
|
|
|
||||
|
||||
|
05-11-2007, 05:09 PM
Part it out is my only advice. No one has the kind of change to dump on a truck all at once.
|
|
|
||||
|
||||
|
05-11-2007, 05:11 PM
+1 you will get what your asking if your seperate rather than sell as a LOT
Racing from a roll is like beating off, it may be fun but its not the real thing. Quote:
|
|
|
|||
|
|||
|
05-11-2007, 05:31 PM
Nawww Ill just keep it if no one wants it. Shit i just built it, I don't want to tear it down lol. I really don't have a place to drive it with out driving 25 miles. If i keep it I'm thinking I'll slam it and gear it up and put some street tires on it. I found a Toyota Celica 1/8 body that looks absolutely sick on it. And fits it pretty good with a little more body trimming on it. Picco 28 8 port with a top end pipe?
Oh yea lol.. Thanks for the Tips bros!!!!
|
|
|
|||
|
|||
|
05-11-2007, 06:04 PM
Hmmm after thinking about it. I could part it out for this.
600.00 for the Roller. thats with wheels and tires 175.00 for motor and BB kit and Pipe and rotstart and pull start. No rotostarter only back plate! 250.00 for the Spectrum and and Airtronics 94359 servo ($139 at tower) and Throttle servo is a futaba 3305 and Rechargeable battery's and JR charger.
|
 |
| Thread Tools | |
|
|
