Thread: awesome!!!
View Single Post
(#17 (permalink))
Old
Czech-it-Out Graphics's Avatar
Czech-it-Out Graphics Offline
I own rocco brocoli
Czech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud of
  
Rating: 0% (0)
Join Date: Nov 2005
Location: Chicago, IL
Send a message via AIM to Czech-it-Out Graphics Send a message via Yahoo to Czech-it-Out Graphics
05-07-2006, 10:41 PM
that may work as long as u used a carbide endmill or something like that. My only concern with that would be that it would not spin fast enough to do a clean cut on most high grade aluminum

Here is a link to my website-
www.czech-it-out-graphics.com
1/29/07 never forget....TTT
Bringing old know-it-all blow hards back to reallity at a forum near you

"Always Imitated, Never Duplicated"
Reply With Quote