Thread: 1pc CNC motor mount for LSP??
View Single Post
(#5 (permalink))
Old
Czech-it-Out Graphics's Avatar
Czech-it-Out Graphics Offline
I own rocco brocoli
Czech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud ofCzech-it-Out Graphics has much to be proud of
  
Rating: 0% (0)
Join Date: Nov 2005
Location: Chicago, IL
Send a message via AIM to Czech-it-Out Graphics Send a message via Yahoo to Czech-it-Out Graphics
01-19-2007, 07:52 PM
i doubt that caused the problem to be honest. an engine doesnt have to have mechanical pinch to be good, MOST motors these days run the best with no mechanical pinch its all about actual compression and seal b/w the piston and sleeve. Unless it starts running sporadically with a terrible tune and high idle just run it

Here is a link to my website-
www.czech-it-out-graphics.com
1/29/07 never forget....TTT
Bringing old know-it-all blow hards back to reallity at a forum near you

"Always Imitated, Never Duplicated"
Reply With Quote